The NSMB Hacking Domain » Sprite Database

Attn
Join our Discord Reminder: don't use Discord as an image host. The links expire after a while.

Views: 35,123,193

0 users online. | 2 guests | 32 bots

12-26-24, 05:03 pm

Sprite DB	By Category
Welcome to the Sprite DB! Here you will find information on how to use any sprite in NSMB. You can also have this database in NSMB Editor if you're using the latest version! All the registered users can also collaborate with the Sprite DB by sharing their sprite data findings. Click any sprite below to edit it. You need to be logged in to edit the sprite database.	All sprites Unknown Known, incomplete Known, complete Uncategorized Platforms and ropes Event controllers Bosses and cutscenes Camera controllers Useless sprites Effects and decorations Other Enemies - Overground Enemies - Underground Enemies - Water Enemies - Snow Enemies - Fire Enemies - Castle Enemies - Ghost House Enemies - Desert Go to sprite ID:
Status
326 total 292 32 2 The above bar needs more green. HELP US MAKE IT HAPPEN! NOW!

ID

Class ID

Name

Last edited by

291

243

Brick Block containing ? Switch

Trigger ID: value at nybble 0-1. If not set, the switch will always show. If set, the switch will only show while this event ID is activated. Slightly buggy if used with multiple use as the switch will pop back up immediately, which looks a bit strange and also causes Mario to be pushed into the air. No "real" glitch.
Target ID: value at nybble 2-3
Settings: list at nybble 4: 0=None,1=Falls,4=Loads at midway,2=Unknown [see note]. If 1, the switch will be movable by environment stuff, such as dropping down when bricks below it are destroyed, or riding along a conveyor belt. If 4, the switch will only show if the level has been started from a midway point. Value 2 is used in 2-3, it may have something to do with the target ID.
Delay on multiple use: list at nybble 5: 0=Instantaneous (no delay),2=Short delay,3=Long delay,1=Very long delay,15=Unknown. [Check this nybble]. This will set how long the switch takes to pop up after the timer expires on a multiple use switch. Value 15 may have something to do with the timer. Maybe it pops up just after target ID is deactivated after activation with timer?
Non-timed event: checkbox at nybble 6 with mask 1
Switch mode: list at nybble 8: 0=Activates target (switches event state),1=Deactivates target (switches event state)
Usage mode: list at nybble 9: 0=Single use,1=Multiple use,2=Unknown
Shift ½ block right: checkbox at nybble 10 with mask 1
Upside down: checkbox at nybble 11 with mask 1. If this is checked, the switch will be facing down. Upside down switches cannot fall.

poudink (rev. 16)