By  KingYoshi on 09-13-15, 04:30 pm |
| Category 'Event controllers', known, fully documented |
TODO:
Move spritedata from ? switch to here. |
| Data files: none |
Sprite fields:
• Triggering event ID: value at nybble 0-1. If not set, the switch will always show. If set, the switch will only show while this event ID is activated. Slightly buggy if used with Multi Use as the switch will pop back up immediately, which looks a bit strange and also causes Mario to be pushed into the air. No "real" glitch.
• Target event ID: value at nybble 2-3
• Settings: list at nybble 4: 0=None,1=Falls,4=Loads at midway. If 1, the switch will be movable by environment stuff, such as dropping down when bricks below it are destroyed, or riding along a conveyor belt. If 4, the switch will only show if the level has been started from a midway point.
• Delay on multiple use: list at nybble 5: 0=Instantaneous (no delay),2=Short delay,3=Long delay,1=Very long delay. [Check this nybble.] This will set how long the switch takes to pop up after the timer expires on a multiple use switch.
• Non-timed event: checkbox at nybble 6 with mask 1
• Switch mode: list at nybble 8: 0=Activates target (switches event state),1=Deactivates target (switches event state)
• Usage mode: list at nybble 9: 0=Single use,1=Multiple use,2=Unknown. 2 is unused.
• Shift ½ block right: checkbox at nybble 10 with mask 1
• Upside down: checkbox at nybble 11 with mask 1. When Super Mario+ hits the Brick Block, the switch will appear where the brick block was and it'll be facing down. Upside down switches cannot fall. |
|
⇨
|
By  Hiccup on 06-22-16, 04:27 pm |
| Category 'Event controllers', known, fully documented |
TODO:
Move spritedata from ? switch to here. |
| Data files: none |
Sprite fields:
• Triggering event ID: value at nybble 0-1. If not set, the switch will always show. If set, the switch will only show while this event ID is activated. Slightly buggy if used with Multi Use as the switch will pop back up immediately, which looks a bit strange and also causes Mario to be pushed into the air. No "real" glitch.
• Target event ID: value at nybble 2-3
• Settings: list at nybble 4: 0=None,1=Falls,4=Loads at midway. If 1, the switch will be movable by environment stuff, such as dropping down when bricks below it are destroyed, or riding along a conveyor belt. If 4, the switch will only show if the level has been started from a midway point.
• Delay on multiple use: list at nybble 5: 0=Instantaneous (no delay),2=Short delay,3=Long delay,1=Very long delay. [Check this nybble.] This will set how long the switch takes to pop up after the timer expires on a multiple use switch.
• Non-timed event: checkbox at nybble 6 with mask 1
• Switch mode: list at nybble 8: 0=Activates target (switches event state),1=Deactivates target (switches event state)
• Usage mode: list at nybble 9: 0=Single use,1=Multiple use,2=Unknown. 2 is unused.
• Shift ½ block right: checkbox at nybble 10 with mask 1
• Upside down: checkbox at nybble 11 with mask 1. When Super Mario+ hits the Brick Block, the switch will appear where the brick block was and it'll be facing down. Upside down switches cannot fall. |
|
