View changes for revision:
By Hiccup on 10-18-14, 04:13 pm |
Category 'Effects and decorations', known, fully documented |
If you plan to make the water move by itself, it is advised to use only speed values between 0 and 127 because it does not work properly with lowering values. |
Data files: • /enemy/suimen_texanim1.nsbtx |
Sprite fields: • Input ID 1: value at nybble 0-1. On ID 1 the water will rise then lower. (This is wrong [E]) • Input ID 2: value at nybble 2-3. On ID 2 the water will rise, but have to be activated again with a stop command to lower. • Water lowering's delay: value at nybble 4. Any value other than 0 will override both Input IDs. • Water rising's delay: value at nybble 5. Any value other than 0 will override both Input IDs. • Opacity: value at nybble 6-7. Modulo 32. 0 is transparent. 31 has the highest opacity. • Tiles to move: value at nybble 8-9 • Speed: value at nybble 10-11. Modulo 128. If lower than 128 then the water will rise, if greater or equal than 128 the water will lower. |
|
⇨
|
By Hiccup on 10-19-14, 09:23 am |
Category 'Effects and decorations', known, fully documented |
If you plan to make the water move by itself, it is advised to use only speed values between 0 and 127 because it does not work properly with lowering values. |
Data files: • /enemy/suimen_texanim1.nsbtx |
Sprite fields: • Input ID 1: value at nybble 0-1. On ID 1 the water will rise then lower. (This is wrong [E version]) • Input ID 2: value at nybble 2-3. On ID 2 the water will rise, but have to be activated again with a stop command to lower. • Water lowering's delay: value at nybble 4. Any value other than 0 will override both Input IDs. • Water rising's delay: value at nybble 5. Any value other than 0 will override both Input IDs. • Opacity: value at nybble 6-7. Modulo 32. 0 is transparent. 31 has the highest opacity. • Tiles to move: value at nybble 8-9 • Speed: value at nybble 10-11. Modulo 128. If lower than 128 then the water will rise, if greater or equal than 128 the water will lower. |
|