The NSMB Hacking Domain » Last spritedb changes

View changes for revision:

Input controller - "And" (If X AND Y, do Z) (164, rev. 23)
By Hiccup on 03-30-15, 07:45 pm
Category 'Event controllers', known, fully documented
This sprite works by allowing up to 4 input IDs to be required to activate a single output. All input IDs must be set to a relevant value. Do not leave any as '0' - if you have less than four, you can enter the same ID into several spaces.
Data files: none
Sprite fields: • Triggering Event 1: value at nybble 0-1 • Target Event ID: value at nybble 2-3 • Triggering Event ID 2: value at nybble 4-5 • Triggering Event ID 3: value at nybble 6-7 • Triggering Event ID 4: value at nybble 8-9 • Three options?: list at nybble 10: 0=Single Use,1=Multi-Use - Hiccup doesn't understand this one,2=Only while All Events are Active (this can be used again and again- also might need better wording • Two options?: list at nybble 11: 0=Activates Target (Switches Event State),1=Deactivates Target (Switches Event State)

⇨

Event Controller - "AND" (If X AND Y, do Z) (164, rev. 24)
By Hiccup on 03-31-15, 07:49 pm
Category 'Event controllers', known, fully documented
This sprite works by allowing up to 4 input IDs to be required to activate a single output. All input IDs must be set to a relevant value. Do not leave any as '0' - if you have less than four, you can enter the same ID into several spaces.
Data files: none
Sprite fields: • Triggering Event 1: value at nybble 0-1 • Target Event ID: value at nybble 2-3 • Triggering Event ID 2: value at nybble 4-5 • Triggering Event ID 3: value at nybble 6-7 • Triggering Event ID 4: value at nybble 8-9 • Three options?: list at nybble 10: 0=Single Use,1=Multi-Use - Hiccup doesn't understand this one,2=Only while All Events are Active (this can be used again and again- also might need better wording • Two options?: list at nybble 11: 0=Activates Target (Switches Event State),1=Deactivates Target (Switches Event State)