By  KingYoshi on 09-13-15, 04:31 pm |
| Category 'Event controllers', known, fully documented |
TO DO:
Move sprite data from ? switch to here. |
Data files:
• /obj/I_switch_ncg.bin |
Sprite fields:
• Triggering event ID: value at nybble 0-1. If not set, the switch will always show. If set, the switch will only show while this event ID is activated. Slightly weird if used with multiple use, as the switch will pop back up immediately, which causes Mario to be pushed into the air.
• Target event ID: value at nybble 2-3
• Settings: list at nybble 4: 0=None,1=Falls,4=Loads at midway. If 1, the switch will be movable by environment stuff, such as dropping down when bricks below it are destroyed, or riding along a conveyor belt. If 4, the switch will only show if the level has been started from a midway point.
• Delay on multiple use: list at nybble 5: 0=Instantaneous (no delay),2=Short delay,3=Long delay,1=Very long delay. This will set how long the switch takes to pop up after the timer expires on a multiple use switch.
• Non-timed event: checkbox at nybble 6 with mask
• Switch mode: list at nybble 8: 0=Activates target (switches event state),1=Deactivates target (switches event state). Switch press-status can be ended by hitting the opposite sw.?
• Usage mode: list at nybble 9: 0=Single use,1=Multiple use,2=Unknown. 2 is unused.
• Shift ½ block right: checkbox at nybble 10 with mask 1
• Upside down: checkbox at nybble 11 with mask 1. Upside down switches cannot fall. |
|
⇨
|
By  Hiccup on 10-29-15, 09:26 am |
| Category 'Event controllers', known, fully documented |
TO DO:
Move sprite data from ? switch to here. |
Data files:
• /obj/I_switch_ncg.bin |
Sprite fields:
• Triggering event ID: value at nybble 0-1. If not set, the switch will always show. If set, the switch will only show while this event ID is activated. Slightly weird if used with multiple use, as the switch will pop back up immediately, which causes Mario to be pushed into the air.
• Target event ID: value at nybble 2-3
• Settings: list at nybble 4: 0=None,1=Falls,4=Loads at midway. If 1, the switch will be movable by environment stuff, such as dropping down when bricks below it are destroyed, or riding along a conveyor belt. If 4, the switch will only show if the level has been started from a midway point.
• Delay on multiple use: list at nybble 5: 0=Instantaneous (no delay),2=Short delay,3=Long delay,1=Very long delay. This will set how long the switch takes to pop up after the timer expires on a multiple use switch.
• Non-timed event: checkbox at nybble 6 with mask
• Switch mode: list at nybble 8: 0=Activates target (switches event state),1=Deactivates target (switches event state). Switch press-status can be ended by hitting the opposite sw.?
• Usage mode: list at nybble 9: 0=Single use,1=Multiple use,2=Unknown. 2 is unused.
• Shift ½ block right: checkbox at nybble 10 with mask 1
• Upside down: checkbox at nybble 11 with mask 1. Upside down switches cannot fall. |
|
