I wanted to have my sprite 155 warps me back and forth within same area but I don't know why it didn't work.
Picture:

I wanted the warp to take me to entrance C. The entrance A lead you to entrance B, then you will fall to the warp and it'll take you to C, and when you enter A again, it'll lead to B then to the warp again. Something like that. But the problem is after I had warped to C and I enter A again, when I fell the warp didn't work anymore, so I stuck. But I think I set the data correctly.
_________________________

---

I never use "Respawn in same area". I use the normal warp mode. Even if you link yourself to the same area it will work.
Respawn in same area always freezes.

I haven't figured out all these values yet, but yes I think the answer is in trying different "warp mode settings".

What would also work is a zone with a 168 sprite set to "toggle stop/start" outside zone. Set the input ID of the warp the same as the output ID of the warp. If the warp settings themselves don't work, do this and it will work. Just place the zone just above the warp sprite by 4 pixels and set the 168 to entering zone.

I tried normal warp mode. But it doesn't work. And the zone helping technique, I can't get it work, probably wrong on IDs setting.
_________________________

---

Still can't make it works, probably the warps should take you to farther location.
_________________________

---